Ricoh DDP70, Maintenance Manual

Page: 75 / 137

5-26
DDP70 Finisher Maintenance Manual
M M L 0 0
5.2.16. E2CA PAPER EXIT OPENING POS. ERROR
5.2.17. E2E5 FNS DRIVER
Figure 5-10. Error Code E2E5
PRIMARY FACTOR; During the Paper Exit Opening operation, the Opening cannot be detected.
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs because
the Paper Exit
Opening does not
operate. 1. The drive system for the
Paper Exit Opening is
faulty. Check:Paper Exit Opening and
its environs.
2. Motor fault. Replace: Paper Exit Opening
Motor (M8).
3.4, 3-3
3. The breaking of cables or
the disconnecting of
connectors. Repair the cable CN1-M8 or reset
the connector in the correct
position.
4. PCB fault. Replace: FS-104H P/K
4.3.11, 4-16
2. This phenomenon
occurs though the
Paper Exit
Opening
operates. 1. The sensor is
contaminated.
Check if the sensor is
contaminated, etc. Cleaning: Paper Exit Opening
Sensor (PS12) and its environs.
3.5, 3-5
2. The mounting of the
sensor is faulty. Reset the Paper Exit Opening
Sensor (PS12) in the correct
position.
3.5, 3-5
3. The breaking of cables or
the disconnecting of
connectors. Repair the cable CN5-PS12 or
reset the connector in the correct
position.
4. Sensor fault. Replace: Paper Exit Opening
Sensor (PS12)
3.5, 3-5
5. PCB fault. Replace: FS-104H P/K
4.3.11, 4-16
Refer to
Figure 5-9
.
PRIMARY FACTOR; Detected that the power supply does not supply the Finisher with the +24V power.
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs. 1. The breaking of cables or
the disconnecting of
connectors. Repair the cable P231-CN9 or
reset the connector P231 or CN9
in the correct position.
2. PCB fault. Replace:FS-104H P/K
4.3.11, 4-16
3. Power Supply fault. Check the Power Supply
1
2
3
4
+5V
+5V RTN
+24V
+24V RTN
POWER SUPPLY
CN9
J/P231
J/P235
3
7
4
8
DDP70
FS-104H P/K