Ricoh DDP70, Maintenance Manual

Page: 57 / 137

5-8
DDP70 Finisher Maintenance Manual
M M L 0 0
5.2.2. E019 LOW STAPLE (R)
E01A LOW STAPLE (F)
PRIMARY FACTOR;
Precaution:
E019: Lack of Rear Side Staple
E01A: Lack of Front Side Staple
If the FINISHER Front Cover is closed after changing the staple cartridge, the Stapler motor
operates some times, still the stapler becomes in a ready condition.
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs due to a
lack of staples.
(the number of
staples is less
than 50) 1. Lack of Staples. Supply the Staple.
2. This phenomenon
occurs though the
staple plates are
in the Staple
Cartridge. (more
than 50 staples) 1. The Staple Cartridge is
incorrectly set. Reset the Staple Cartridge
correctly.
2. The breaking of cables or
the disconnecting of
connectors. Repair the cable CN6-CN109,
CN6-CN110 or reset the
connector in the correct position.
3. No Staple Sensor in the
Stapler Unit is fault. Replace: Stapler Unit
4.3.4, 4-8
4. PCB fault. Replace: FS-104H P/K
4.3.11, 4-16