Ricoh DDP70, Maintenance Manual

Page: 56 / 137

Troubleshooting
5-7
M M L 0 0
5.2.1. E009 SHIFT TRAY FULL 1
E00A SHIFT TRAY FULL 2
Figure 5-1. Error Codes E009 & E00A
PRIMARY FACTOR; E009: Detected that the Tray Lower Limit Sensor of the Finisher is turned ON.
E00A: Detected that the stacked paper on the Shift Tray of the Finisher is abnormal.
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs. 1. The Shift Tray is full. Remove: Paper
2. STACKER FULL
is detected though
the Shift Tray is
not full of paper.
(in case of the
paper on the Shift
Tray is not
abnormal) 1. The sheet number
stacked on the Shift Tray
reached the number for
the paper full detection. Remove: Paper
2. The breaking of cables or
the disconnecting of
connectors. Repair the cable CN4-PS3 or
reset the connector.
3. Sensor fault. Replace: Tray upper limit
sensor (PS2)
Tray lower limit
sensor (PS3)
3.5, 3-5
3.5, 3-5
4. PCB fault. Replace: FS-104H P/K
4.3.11, 4-16
3. STACKER FULL
is detected though
the Shift Tray is
not full of paper.
(in case of the
paper on the Shift
Tray is abnormal) 1. The condition of the
paper stacked on the Shift
Tray is abnormal. Remove: Paper
2. The breaking of cables or
the disconnecting of
connectors. Repair the cable CN4-PS3, CN4-
PS7 or reset the connector.
3. Sensor fault. Replace: Tray upper limit
sensor (PS2)
Tray lower limit
sensor (PS3)
3.5, 3-5
3.5, 3-5
4. PCB fault. Replace: FS-104H P/K
4.3.11, 4-16
FS-104H P/K
1
2
M3
M3 DRV-F
M3 DRV-R
CN103
1
2
TRAY UP-DOWN MOTOR
CN8
TRAY LOWER
LIMIT SNS
PS3
4
5
6
VCC
PS3 IN
GND
TRAY UPPER
LIMIT SNS
PS2
1
2
3
VCC
PS2 IN
GND
CN4
STAPLE PAPER
EXIT SNS
PS7
7
8
9
VCC
PS7 IN
GND
1
2
3
1
2
3
1
2
3