Ricoh D093, Service Manual

Page: 137 / 779

Table (B854)
SM 3-59 D093/D094
Inst
allation
ƒ The top edge must be flat and parallel to the edge of the cover. The right edge of
the mylar must be parallel to rib .
4. Attach the other end of the mylar to the bottom edge of the cover .
5. Do this procedure again to attach the other narrow mylar to the right side of the cover.
6. Reattach the cover to the back of the main machine ( x 2).
Attach the Wide Mylars to the Back of the Table
1. On the left side of the rear plate [1], find the straight line [2] and, patterns [3].
2. Use a clean cloth, moistened with a small amount of alcohol, to clean this area and the
bottom edge of the cover.
3. Remove the tape from each end of one of the wide mylars.
4. Align the end with the narrow tape with the top edge [4] of the rear plate. Make sure that the
right edge is parallel to the vertical lines on the plate, then push down.
5. Turn the end with the wide tape against the plate, and align its corner [5] with the inverted
“L” pattern embossed on the plate , then push it against the rear plate.
6. Make sure that the tape surfaces are pushed fully against the rear plate.