Rich electric Invertek SuperCombi SC-1500-12X, User Manual

Page: 113 / 155

Rich Electric Co. “SuperCombi” User Manual V7.19 Copyright 2009
Page 113
H2 Group (DC Controller)
H2-01: DC Load Enable
Main Menu>Programming>ENT> DC Controller 2 >ENT
Setting Function
H2-01=1
(Initial setting)
DC Controller 2 is Enabled (active)
H2-01=0 DC Controller 2 is Disabled
H2-02: Low Voltage Disconnect
Main Menu>Programming>ENT> DC Controller 2 >ENT
z
Use constant H2-02 to adjust the DC controller disconnection voltage. When the voltage set in
constant H2-02, the DC controller will be disconnected.
H2-03: Low Violate for ?sec
Main Menu>Programming>ENT> DC Controller 2 >ENT
z
Use constant H2-03 to determine the minimum disconnect detection time. Once the input
voltage is lower than H2-02, for longer than H2-02, The DC controller will disconnected load to
prevent the battery from being exhausted.
H2-04: Reconnect Voltage
Main Menu>Programming>ENT> DC Controller 2 >ENT
z
Use constant H2-04 to adjust the DC controller reconnection voltage. When the voltage set in
constant G1-02, the DC controller will be allow the load to connect to the battery.
H2-05: Reconnect for ?sec
Main Menu>Programming>ENT> DC Controller 2 >ENT
z
Use constant H2-05 to determine the minimum reconnection detection time. Once the battery
voltage is higher than H2-04, for longer than H2-05 The DC controller will reconnect to the
load.
H2-06: Over Voltage Cut Out
Main Menu>Programming>ENT> DC Controller 2 >ENT
z
Use constant H2-06 to adjust the DC Load Max output voltage. This voltage will turn “OFF”
the DC Load output to protect the load against over voltage output.