27
4.8.4
Delete all radio transmitters programmed
D
Fig. 13:
Delete all radio transmitters programmed
1. Pull out the mains plug of the drive.
2. Press and hold the oval programming button (PROG button) (D).
3. Plug the mains plug into the mains socket while keep pressed the programming button (PROG button) (D)
ð
The dot (A1) on display flashes quickly
ð
All radio transmitters codes are deleted.
4.8.5
Menu 3 + Menu 4: Adjustment of the end race positions
D
B
Fig. 14:
Setting the desired "OPEN" position
1. Hold pressed the programming button (PROG button) (D) for approximately 3 seconds
ð
The display shows "3".
2. Press the OPEN button (B
⬆
) and check that the garage door opens.
NOTICE
If the garage door moves in the wrong direction, command a change of direction by holding pressed the programming button (PROG button) (D) for approximately
5 seconds until a light appears.
3. Keep the OPEN (B
⬆
) button pressed until the garage door is opened in the desired position. If needed, press the CLOSE button (C
⬇
) to adjust the position.
4. Once the garage door is OPEN at the desired position, press the programming button (PROG button) (D) to confirm it
ð
The display shows
Menu "4"
.
5. When the display flashes, press the CLOSE button (C
⬇
).
6. Keep the CLOSE (C
⬇
) button pressed until the garage door is CLOSED in the desired position. If needed, press the OPEN button (B
⬆
) to adjust the position.
D
C
Fig. 15:
Setting the desired "CLOSE" position
7. Once the garage door is at the desired end position CLOSE, press the programming button (PROG button) (D) to confirm it
ð
The display shows "0".
4.8.6
Force learning cycle
WARNING
Crush and impact hazard !
During the force learning cycle, the drive automatically learns the normal mechanical force required to open and close the garage door.
Force limits are deactivated until the conclusion of the learning cycle. The door movement will not be stopped by an obstruction!
•
Keep a sufficient distance from the entire path of motion of the garage door!
NOTICE
• During the force learning cycle the display shows "0". Do not interrupt this procedure. After completing the force learning cycle, the "0" on the display must
disappear.
•
The force learning cycle always starts from fully closed position of the door.
NOTICE
•
We recommend to select the door type in menu 8 before carrying out the force learning cycle.
B
Fig. 16:
Force learning cycle
1. Press the OPEN button (B
⬆
) or use the transmitter. The garage door moves from fully closed position to fully open position.
2. Press the OPEN button (B
⬆
) again or use the transmitter. The garage door will close completely. After approximately 2 seconds, the "0" on the display will disappear.
NOTICE
•
In case the "0" on the display will not disappear, repeat the procedure.
•
After 3 failed attempts, "3" is displayed and you are prompted to repeat the setting of the end positions, see also "Menu 3 + Menu 4: Setting the end positions".
G
B
