Eliminate all sources of sparks or flame (i.e. smoking, open flames, or tools
that can cause sparks) in the areas where fuel is mixed, poured, or stored.
Do not smoke while handling fuel or while operating the machine.
Operate the machine only in well ventilated areas.
Never start or run the engine inside a closed room or building.
Exhaust fumes contain dangerous carbon monoxide.
3.2- General safety
Never touch the muffler guard with bare hands while the engine is in operation or immediately after
shutting down the engine.
Doing so could result in serious burns because of high temperature.
Keep the handles dry, clean and free of grease, oil or fuel mixture
Operate the product only in outdoors or in well ventilated areas.
Do not operate the product while standing on a ladder or any other unstable footing location.
1. Become familiar with the controls and the proper use of the equipment.
2. Store idle machine. When not in use, product should be stored in a dry, high or locked up
place, out of reach of children.
3. Do not force the tool.
It will do the job better and safer at the rate speed for which it is intended.
The product will do a better and safer job if it is used only for the purposes it was designed for.
4. Remove adjusting keys and wrenches
Form the habit of checking to see that keys and adjusting wrenches are removed from the
machine before operating it.
5. Defective switches or other part that is damaged should be properly repaired or replaced by an
authorized service centre. Do not use the machine if the switch does not turn it on and off.
6. Warning
The use of any accessory or attachment, other than those recommended in this instruction
manual, may present a risk of injury to persons or animals and may cause damages.
The user or operator is solely responsible for accidents or hazards or any damages or injury
caused to properties and/or persons and/or animals.
The user/operator is responsible for the safety of third persons present or entering the work area.
7. Remarks
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product
especially for any matters that are not referred in the above
3.3- Safety precautions
3.3.1- Initial preparation before operation
- When you operate the blower, always wear full-length trousers, as well as sturdy, closed footwear
that provide good support. Do NOT operate the blower wearing shorts, when barefoot or wearing
open sandals!
- Do not wear loose clothing or jewelry that can be drawn into the air inlet. Keep long hair away from
the air inlet.
Under no circumstances should jewellery, any other body ornamentation, or loose clothing be worn
while operating the tool as these items could be drawn into the suction orifice.
When working outdoors, rubber gloves and non-slip footwear should always be worn.
If you have long hair, put it in a hair net.
- Wear protective equipment and always wear protective goggles while operating the tool.
