Manual CE (SAGOMA _GB)
Before loading make sure, checking through the transparent protection of the cups compartments,
that the central stack of cups is in a position suitable for filling (that is to say with the hollow side
facing the operator). Should this not be the case, then switch on the machine inserting the service
key into the safety switch. Press and keep pressed the
key PCC
inside the machine on the CPU
protection, until the central stack of cups reaches the correct position.
Extract the safety switch.
ATTENTION: carry out the loading of cups only when the machine is switched off. Do not
attempt to manually rotate the central stack.
Proceed to the loading as follows:
open the upper cover of
the cup feeder;
pull the two mobile sides towards
the outside, until they are
blocked; slide the stacks of cups
towards the inside of the
machine, keeping them in
vertical
position.
The edge of the upper cup of each
stack must reach a height between
the
limits indicated on the
sticker of instructions placed inside
the cup feeder. This allows a
regular operation of the inside
mechanisms of the cup feeder
itself;
close the cup feeder with the upper cover.
11.2.4 Refilling of stirrers
The stirrers feeder is standard fit on the models
E
, as an optional in models
H
.
It is recommended to use only stirrers suited to automatic vending machines. The thickness of the
stirrers must range between 1.2 and 1.8 mm and their length must be approx. 89 mm.
If stirrers with different dimensions from those specified must be used, please contact the technical
service of M.P.R.
24/24
