Manual CE (SAGOMA_GB)
Remove the plates of
the superior filter
Turn upwards the
superior filter,
dismount and clean
it with hot water
removing all coffee
powder.
Turn the group in the
position of ejection waste
grounds and overturn the
slide of coffee
Dismount the inferior
filter and clean it with
hot water removing all
coffee powder.
- after completion of these operations, refit the cover of the lower filter and the cover of the coffee
group.
15.1.5 Regeneration of the water softener filter
This section applies only to machines equipped with water softener filter.
Check that the maximum quantity of softened water between two filter regenerations has not been
reached. The table indicates the quantity of water which can be softened by the model supplied
with the espresso machine, according to the water hardness grade. As a reference for water
hardness grade, keep to the value taken when the machine was installed (section "Connection to
the mains water supply").
°FF
I
20°
1200
30°
1000
40°
900
60°
700
80°
500
The filter can be regenerated without removing it from the machine (keep a container of 30l
capacity near the machine) this operation can be carried out near a 3/8" mains connection and a
drain.
- close the tap of the mains water supply, outside the machine;
- insert the drain pipe of the upper tap in the container;
- turn the levers of the upper and lower tap towards the right hand
side and wait for the water to totally flow out of the filter;
- loosen the upper fixing knob, remove the cover of the water
softener and pour 1 Kg of fine salt into the filter;
- place the cover again and fix it with the knob;
- turn the lever of the upper tap towards the left hand side;
- open the tap of the mains water supply, outside the machine;
- leave the water flow in the container until it is clear and tasteless.
The regeneration takes about 30 min.
- turn the lower tap lever towards the left hand side. The
regeneration is completed.
55/55
