R-SR-1309 & R-SR-1310
2
2-7
Installation
10-04-2017
2.2.3 Installation of the shower cubicle
Make sure to place the shower cubicle on a level and
smooth floor, which seamlessly matches the other parts of the floor.
Make sure the shower cubicle will remain
accessible from the back, to perform maintenance work.
1.
Install
the shower basin.
–
Level
the shower basin in the location
where it will be installed (see Drawing 1-1).
–
Connect
the flexible hose from the
siphon to the water discharge in the floor (see Drawing 1-2).
Make sure the water discharge is
unobstructed. If it is not, you can turn the
siphon until it is in the correct direction.
–
Tighten
the nut and the bolt of the
support legs after adjustment (see Drawing 1-3).
2.
Install
the shower panels.
–
Place
the glass rear panel with the aluminium corner profiles
onto the shower basin; in the groove intended for it (see Drawing 2-1).
–
Place
the glass side panels onto the shower basin; in the grooves on
both sides of the glass rear panel that are intended for these (see Drawing 2-2).
–
Mount
the glass side panels onto the rear panel using 4.2 x 12 mm screws.
Before mounting, seal all bolt holes carefully. Use acid-free sealant.
Drawing 1-2
Drawing 1-1
Drawing 1-3
4.2 x 12 mm
Drawing 2-1
Drawing 2-2
