R-SR-1309 & R-SR-1310
2
2-13
Installation
10-04-2017
7.
Install
the computer box and the steam generator.
–
Carefully screw
the frame with the computer box and the steam generator onto the
back of the glass rear panel, using an M4 x 3.5 mm bolt and nut (see Drawings 7-1 and 7-2).
On both sides, place a washer between the bolt and the nut.
8.
Connect
the steam hose (see Drawing 8-1).
–
Connect
the drain pipe to the “
DRAIN
”.
–
Connect
the cold-water hose to the “
WATER INLET
”.
–
Remove
the cap nut from the “
STEAM INLET
”.
–
Connect
the drain pipe to the steam generator.
–
Connect
the steam hose to the “
STEAM OUTLET
”.
–
Connect
the other end of the steam hose to the steam dispenser.
Place a silicone sealing ring in the couplings.
Bend the steam hose up somewhat, immediately after the steam generator, to prevent
hot water from running into the cubicle via the steam dispenser (see Drawing 8-2).
Drawing 7-1
M4
x 35 mm
Drawing 8-1
Drawing 8-2
M4 x 35 mm
Drawing 7-2
