REMKO Smart Com, Instructions For Use Manual

Page: 13 / 32

5 Checking that the
Smart Com is enabled
Check the status of the activation as follows:
User level
¯
Information
¯
Basic information
¯
Status
¯
Smart Com
¯
Activated Deactivated
Enabling the Smart Com function displays the acti-
vation at this level.
After the activation has been checked, switch off
the power to the heat pump again and replace the
SD card with the original card that you had
removed at the beginning.
After switching on the heat pump again, the instal-
lation of the Smart Com function is complete.
6 Configuring the
Smart Com function
The settings for the Smart Com function can be
made in the Expert level. To do so, touch the
REMKO logo in the upper right corner of the dis-
play.
User level
¯
Activate Expert level by touching the REMKO
logo at the top right
¯
Password input using “+/-”
(Password: 0321)
¯
Confirm password with “OK”
¯
Expert level
Enabling and programming
This function is not activated ex works. You must
set the following parameters to activate this func-
tion:
Expert level
¯
Settings
¯
Default settings
¯
Interfaces
¯
KNXnet/IP
Your KNXnet/IP data can be programmed at this
level.
First start with the physical address of the inter-
face.
KNXnet/IP
¯
IA for the KNX interface
13