REMKO Smart Com, Instructions For Use Manual

Page: 12 / 32

Function as delivered
As delivered, the following parameters are set
depending on the manufacturer:
n Physical address of the IP interface: 15.15.255
(= FFFF hex)
n IP address assignment via DHCP
IP interfaces can be set to the factory settings.
This procedure deletes parameter settings.
For information on the procedure, see the man-
ufacturer's interface documentation.
4 Installing the
Smart Com software
The Smart Com function provides you with the
option of controlling your REMKO heat pump via a
KNX/EIB system.
The following pages describe installing the Smart
Com function on the REMKO Smart Control con-
troller.
NOTICE!
Before removing and inserting the SD card, the
system must be powered down!
1. After you have powered down the system,
remove the SD card from the I/O module.
Fig. 6: Removing the SD card
2. Insert the SD card for activating the Smart
Com function and turn on the power to the
system again. The installation then starts
automatically.
3. The installation of the Smart Com function is
finished when the default display is shown
again.
The activation process can be repeated with the
same SD card after a software update or re-
commissioning.
NOTICE!
IMPORTANT!
If you want to replace the complete Smart Con-
trol controller, a new Smart Com SD card is
required.
REMKO Smart Com
12