3. If coupling was successful,
the unit sends a serial number
to the wireless remote control
and the wireless symbol is
displayed.
4. The swimming pool
dehumidifier confirms
the connection by displaying
the code “Conn” for a period
of 3 seconds.
This procedure can also be carried
out using several remote controls
so that an air dehumidifier can
be controller by several remote
controls.
Connecting the antenna
The antenna is located on
the control board inside the unit
or can be fitted there. This will
be pre-installed if the unit
is delivered together with
the remote control.
Before fitting the antenna,
disconnect the unit from the power
supply. Then slacken the two
fastening screws on the underside
of the unit, tilt the front cover of
the unit and lift it up. In the upper
right area, remove the two screws
on the board cover and remove
the cover. Pull the control board
forwards, screw the antenna
into place and bend it forwards.
Once the antenna is screwed in
place and the board has been
returned to the previous position,
the unit can now be provided
with power in order to couple it
with the wireless remote control.
Then screw the housing parts back
into place.
Switching on and coupling
the remote control
The wireless remote control must
be coupled with the unit before
it can be used. To do so, carry out
the following steps.
1. Insert the batteries provided
into the battery compartment
on the rear of the wireless remote
control.
2a. The remote control will search
for the unit for two minutes.
During this time, the remote
control display flashes every
2 seconds.
2b. During the search phase,
hold down the Up and Down
keys on the operator panel of
the control board at the same time
for 5 seconds.
Coupling
Connecting the antenna
Location of the control board
Coupling failure
If the wireless remote control
fails to couple with the unit,
the fault symbol becomes visible,
“Conn” is shown permanently
on the display and the wireless
symbol flashes.
The wireless remote control
needs to be reset before a new
coupling attempt can be made.
To do so, hold the Left key on
the wireless remote control down
for 10 seconds.
17
Summary of Contents for SLN 45
Page 2: ......
Page 25: ...1 10 2 3 4 5 6 7 8 9 11 12 13 14 15 16 17 18 19 21 20 22 Exploded view of the unit 25...
Page 34: ...Notes...
Page 35: ......