28
29
15180-101 Rev. F
15180-101 Rev. F
Operation
(continued)
Measurement Mode
(continued)
UV Measurement - LensChek Pro
The LensChek Pro can measure the percentage of UV light that
passes through the lens. Set the “UV Measure” to "On" in the
Setup Menu. When the lens value is stored, the percentage of
UV light that passes through the lens is automatically displayed
on the screen. Refer to Figure OP-26.
PD Measurement - LensChek Pro
The LensChek Pro can measure the PD distance for a pair of
glasses.
1. Set the “PD Measure” to "On" in the Setup Menu.
2. Place the framed lens on the lens stand and lower the lens
holder softly on the lens.
3. Pull out the lens table so that the bottom of the lens touches
the lens table, and the corresponding Nose Pad is aligned in
the center of the glasses. Refer to Figure OP-27.
4. When measuring the lens, the monocular PD measurement
will automatically show up on the side of the lens that is being
measured. Refer to Figure OP-28.
5. To measure the other lens, select the opposite lens by press-
ing the
L/R
button and follow the above procedure to mea-
sure the other lens.
6. When measuring the other lens, the monocular PD measure-
ment will appear on the side of the lens being measured.
7. The binocular PD measurement will appear underneath the
alignment target. Refer to Figure OP-29.
Figure OP-26 UV Measurement
Figure OP-28 PD Measurement
Figure OP-29 Total PD Measurement
Figure OP-27 Orienting Glasses
Nose Pad
