13795-101 Rev. F
11
Articulating Wall Mount
(continued)
Wood Stud Wall Mounting
Hardware provided is for attaching the mount in standard thick-
ness drywall or plaster into wood studs. Installers are respon-
sible to provide hardware for other types of mounting situations.
1. Remove the part of the mount that attaches to the back of
the ClearChart 4 from the part of the mount that attaches
to the wall by sliding that part up and removing it. Refer to
Figure SU-05.
2. Make sure that mounting screws are anchored into the Cen-
ter of the studs. Use a stud finder to locate the Center of the
studs. Use of an edge to edge stud finder is highly recom-
mended. Use a level to draw a vertical line down the center
of the stud. Refer to Figure SU-06.
3. Place the wall plate on the wall as a template and mark the
center of the three mounting holes. Make sure the mounting
holes are on the stud center line. Refer to Figure SU-06.
4. Drill three 3 mm (1/8 in.) diameter holes 50 mm (2 in.) deep.
Make sure that the wall plate is level, and secure it using the
screws. Level the plate then tighten all fasteners. Refer to
Figure SU-07.
Figure SU- 06 Mark Screw Holes
Level
Stud
Mark 3
Screw
Holes
Install 3
Screws
No Wall
Anchors
Needed
Figure SU- 07 Mount to a Wood Stud
Installation, Features, & Functions
(continued)
This Part
Mounts
To Wall
Figure SU- 05 Disconnect Two
Parts of Mount
Slide Up to
Remove
This Part
Mounts To
ClearChart 4
