Bellavista® B36XTE-10 Gas Fireplace
|
21
|
21
installation
7) From the outside top of the firebox -
remove the intake cover plate
by removing the 4 - 1/4" x 1/2 " screws. See Diagram 7.
6) From the outside top of the firebox -
remove top insulation cover
plate and insulation filling - by removing 4 screws. See Diagram 6.
Discard cover plate and insulation filling.
5) From the outside rear of the firebox,
remove the intake collar
assembly. Remove the 4 - 1/4" x 1/2" screws. See Diagram 5.
Diagram 5
Exhaust
Assembly
Intake Collar
Assembly
Diagram7
Diagram 6
Before proceeding to Step 8
, inspect condition of all gaskets.
DO NOT install parts with damaged gaskets. Replace if necessary
with spare gaskets supplied.
8)
From the inside of the firebox,
place the exhaust assembly into
position as shown in Diagram 8 and secure with 8 - 1/4" x 1/2" screws
(Diagram 9). Ensure all screws are tight, but do not over tighten.
All 8 screws must be used.
Diagram 8
Diagram 9
10)
From the outside rear of the firebox,
install the intake cover plate with
4 - 1/4" x 1/2" screws. Ensure all screws are tight, but do not over tighten.
All 4 screws must be used.
11)
Set vent restrictor accordingly - see next page.
12) From inside the firebox,
re-install the baffle plate and heat
deflector - reverse steps 2 & 3.
9)
From the outside top of the firebox
, install the intake collar assembly.
Secure with 4 - 1/4" x 1/2" screws. Ensure all screws are tight, but do not
over tighten.
All 4 screws must be used.
Diagram 11
Intake Collar
Assembly
Exhaust
Assembly
Diagram 10
13) From inside the firebox
, reinstall the top heat deflector by placing 2 screws.
Heat Deflector
Diagram 2
14) From inside the firebox
, reinstall the baffle plate by placing 4 screws
- replace top front screw first. Leave loose - until rear screws installed.
See Diagram 3.
Baffle Plate
Diagram 3
Note
: Reuse existing screw holes - do not make new holes. Tighten screws.
