18
|
Bellavista® B36XTE-10 Gas Fireplace
|
18
installation
FINISHING
Non-combustible
Material
J-style Trim
or metal corner bead
may be used to finish these
edges
Non-combustible
Material
Non-combustible
Material
Diagram 2
Diagram 1
IMPORTANT FINISHING DETAIL NOTE:
Before placing unit into final position - it is important to know the total
thickness / height of finished hearth (tile, carpet, etc.) The base of the
fireplace should be level or higher than the finished hearth height.
Important:
Finishing materials such as tile, river rock, etc,
must not
protrude
beyond the front facing flanges the sides and top of the firebox opening.
Note:
All non-combustible facing material should butt up cleanly
to the flanges around the firebox opening.
Rough edges will be visible from the front view with the
flush Flush Panels or flush panels - if not using the optional
finishing trim.
To maintain a clean finished edge - it is recommended to
install the non-combustible facing material with the finished
edge against the fireplace / nailing strips.
Alternatively, you can use J Style Trim or Metal Corner Bead
to cover cut edges of the non-combustible facing material.
UNIT ASSEMBLY PRIOR TO INSTALLATION
BEFORE YOU START
The Top Facing Support, the Side Nailing Strips, the 2 Top Standoffs and the Flue Collar must be correctly positioned and attached before the fireplace
is moved into position.
TOP STANDOFF ASSEMBLY
The top standoffs are shipped in a flat position and must be folded into shape and
attached.
1)
Take each standoff and bend into the correct shape. Bend up at the bend lines
until the screw holes in the standoff and the pre-punched slots on the fireplace
top line up. Be sure to use correct slots, they are marked.
2)
Attach the standoff securely to the top with 2 screws per standoff (on opposite
corners).
