24
|
Regency
®
PG36 Gas Fireplace
installation
Log Set Installation
Read the instructions below carefully and
refer to the diagrams. If logs are broken do
not use the unit until they are replaced. Broken
logs can interfere with the pilot operation.
The gas log kit (Part # 512-930) contains the
following pieces:
a) 02-49 Rear Log
b) 02-55 Middle Left Log
c) 02-50 Front Left Log
d) 02-53 Center Left Log
e) 02-51 Front Bottom Log
f) 02-54 Center Right Log
g) 02-52 Middle Right Log
h)
Embers
i)
Vermiculite
NOTE: If you will be installing the
optional Brick Panels, install the
Brick Panels prior to installing
the logs.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care -
do not force into position.
2) Sprinkle the vermiculite around the firebox
base.
Vermiculite
Vermiculite
Vermiculite
The "02" refer numbers (i.e. 02-49) are
molded into the rear of each log.
3) Place the Log 02-49 on the rear log support
pins with the flat side to the back.
5) Position Log 02-53 across the cutouts in
Logs 02-49 and 02-51 with the notch on the
left side of the log fitting into the 2nd grate
tab.
Cutouts
2nd Grate Tab
02-53
02-49
02-51
Bracket
Bracket
02-49
02-51
02-49
02-51
4) Place Log 02-51 on the front right side of
the burner. Push the back of the log against
the 2 brackets with the notch on the bottom
right side of the log fitting into the right side
of the grate.
Rear Bracket
Front Brackets
Notch
02-55
02-50
02-49
02-51
02-53
02-49
02-51
02-53
02-55
02-53
02-50
02-55
02-53
6) Place the bottom left front edge of Log
02-55 against the rear bracket on the burner
tray and rest the log on the cutout on
Log 02-53.
7) Sit Log 02-50 on the front left side of the
burner. Push the back of the log against
the 2 front brackets with the notch on the
bottom of the log fitting into the first grate
tab.
