30
|
Bellavista® B36XTCE-11 Gas Fireplace
installation
Reducer (946-758)
Minimum Height Requirement of
49” (1245mm) from base of unit
when using reducer
VENTING
DIRECT VENT SYSTEM (FLEX)
HORIZONTAL TERMINATIONS ONLY
These venting systems, in combination with the B36XTCE Direct Vent Gas Fireplace, have been tested and listed as a direct vent heater system by Warnock
Hersey. The location of the termination cap must conform to the requirements in the Vent Terminal Locations diagram in the "Exterior Vent Termination Loca-
tions" section.
Regency Direct Vent (Flex) System Termination Kit (Part # 946-515) includes all the parts needed to install the B36XTCE with a maximum run of 4 feet.
1)
6-7/8" dia. flexible liner (4 ft. length)
2)
4" dia. flexible liner (4 ft. length)
3)
spring spacers (4)
4)
thimble (2)
5)
AstroCap
termination cap (1)
6)
screws (12)
7)
tube of Mill Pac (1)
8)
plated screws (8)
9)
screws #8 x 1-1/2" Drill Point, Stainless
Steel (4)
1)
6-7/8" dia. flexible liner (10 ft. length)
2)
4" dia. flexible liner (10 ft. length)
3)
spring spacers (7)
4)
thimble (2)
5)
AstroCap
termination cap (1)
6)
screws (12)
7)
tube of Mill Pac (1)
8)
plated screws (8)
9)
screws #8 x 1-1/2" Drill Point, Stainless
Steel (4)
If longer runs are needed, the Regency Direct
Vent system (Flex) # 946-516 includes all the
parts needed to install the B36XTCE with a
maximum 10' run.
Notes:
1. Liner sections should be continuous without any joints or seams.
2. Only Flex pipe purchased from Regency may be used for Flex installations.
Must purchase separately
Summary of Contents for B36XTCE-11
Page 70: ...70 Bellavista B36XTCE 11 Gas Fireplace parts list 13 12 19 40 38 39 41 MAIN ASSEMBLY ...
Page 76: ...76 Bellavista B36XTCE 11 Gas Fireplace warranty ...
Page 77: ...Bellavista B36XTCE 11 Gas Fireplace 77 notes ...
Page 78: ...78 Bellavista B36XTCE 11 Gas Fireplace notes ...
