Regen B36XTCE-11, Installation And Operation Manual

Page: 67 / 80

Bellavista® B36XTCE-11 Gas Fireplace
|
67
maintenance
REMOVING VALVE
10. Remove the 8 Phillips head screws securing
the valve tray assembly in place (Diagram
5) and then lift the entire assembly out
(Diagram 6).
1.
Shut off the gas and electrical supply.
2. Remove the mesh barrier.
3. Open the flush door and remove the door.
4. Remove the logs.
5. Remove the burner/grate assembly by
removing the 2 Phillips head screws.
Diagram 1: Remove the left and right screws.
Diagram 2: Slide burner assembly to the left
and then remove.
7. Remove the 2 screws securing the rear log tray
and lift out. Diagram 3
Orifice
9. Disconnect the EV1, EV2, and ground wires
from the valve - as shown below.
Diagram 3
Diagram 5
Diagram 8
Diagram 6
INSTALLING VALVE
1. Place new valve tray into position
2. Reinstall the 8 hold down screws.
3. Hook up the 2 TP and 2 TH wires to the ap-
propriate connections on the valve.
4. Reinstall the rear log tray.
5. Install burner/grate assembly
6. Hook up the gas line and check for gas leaks with
a soap and water solution or a gas leak detector.
(Do not use open flame for leak testing.)
7. Fire up the unit temporarily
8. Check the manifold pressure.
9. Reinstall the logs and brick panels as needed.
10. Reinstall the door and replace the louvers.
11. Fire up the unit again and check for proper flame
appearance and glow on logs.
6. Slide the burner assembly to the left to release
it from the orifice, then lift it out.
8. Disconnect the inlet gas line.
EV1 EV2
Diagram 4