Regal 38 SAV 2019, Owner'S Manual

Page: 200 / 297

200
Seakeeper
If installed, the Seakeeper uses gyroscopic
principles to reduce boat motions in waves
and wakes independent of boat speeds. A
typical unit consists of a Gyro assembly, a CAN
communications cable, and a helm display.
If installed, the Seakeeper is located under the aft
cockpit of your vessel. The unit’s cycling is controlled
by an electronic controller and a hydraulic brake
throughout each roll cycle as to supply maximum
anti-roll torque and limits mechanical contact with
the hard stops that limit the gimbal angle travel.
The Seakeeper operates from DC (direct current)
and the unit is part of the 2 house battery circuitry.
There is a dedicated 100 amp breaker on the fire
wall.
Seakeeper Display
The helm display is used to start, operate, monitor
and shutdown the Seakeeper. Sensors, alarms,
and shutdowns are provided to allow unattended
operation. The display provides information in
the event of an alarm. Select alarms can cause
precession to stop and start the unit to coast down.
TYPICAL SEAKEEPER 3
AVOID SERIOUS INJURY!
ENSURE ALL BODY PARTS & CLOTHING
ARE KEPT CLEAR OF THE SEAKEEPER
WHILE IT IS CYCLING.
WARNING
WARNING
AVOID SERIOUS INJURY!
DO NOT REMOVE THE COVERS FROM
THE UNIT OR CONTACT ANY PARTS
WHILE THE UNIT IS PRECESSING.
MAINTENANCE SHOULD NOT BE DONE
UNLESS THE SEAKEEPER IS LOCKED AND
FLYWHEEL HAS STOPPED SPINNING.
ON/OFF SWITCH W/TOUCH CONTROL
After 12 volt power is present. the Seakeeper
screen will energize and a home screen will
appear. Here the ON/OFF touch screen button
will appear grey (OFF). Once the button is
pressed it will change to blue (ON) and menu
button is used.