Regada SP 0.1, Installation, Service And Maintenance Instructions, Page: 4 / 35

2 SP 0.1, SPR 0.1
The Installation, Service and Maintenance Instructions are drawn up according to requirements of EC Executive
Nr. 2006/42/EC "Uniform requirements for machines and devices from the point of view of safety and health
care", to save life and health of users and to avoid material damages and exposure environment to danger.
1. General data
1.1 Purpose and applications
Electric part-turn actuators (hereinafter EA ) of SP 0.1 (hereinafter SP ) or SPR 0.1 (hereinafter
SPR ) types are high-powered electric-mechanical products designed for direct installations onto
controlled devices (regulating bodies -valves, etc.). EA of SP types are provided for remote control of
closing bodies, and EA of SPR types for automotive control of regulating bodies in both directions of
their movement. They can be equipped with means of measuring and control of technological
processes where an unified analogue direct current or voltage signal is an information bearer on their
input and/or output. They can be used in heating, energy, gas, air-conditioning and other technological
systems, which they are suitable for, regarding their features. They are connected with controlled
devices with a flange according to ISO 5211 and a coupling or using a stand and a coupling/a lever.
Notes:
1. With EA having a built-in controller, in end position it is impossible to expect that the tight
closing will be achieved by means of control signals.
2. It is forbidden to use EA as a lifting mechanism!
3.
Switching of actuator by a semiconductor components/switches have to be consulted with
producer.
1.2 Safety instructions
EA of SP and SPR types are reserved technical devices with higher rate of danger,
with possibility of installation in areas specially danger regarding casualties caused by
electric current.
Electric actuators are according to directive LVD 2006/95/EC and standard IEC 61010-
1:2010 assigned for installation category II (overvoltage category).
Product influence to environment
Electromagnetic compatibility (EMC): the product complies with the requirements of the Directive
2004/108/EC of the European Parliament and of the Council on the approximation of the laws the
Member States relating to the electromagnetic compatibility and with the requirements of standards
as well EN 61000-6-4:2007+A1:2011, EN 61000-6-2:2005, EN 61000-3-2:2014 and EN 61000-3-
3:2013.
Vibrations caused by the product: product influence is negligible.
Noise produced by the product: The maximum allowable noice level (A) of the product measured
in a place of operation is 62 dB (A).
Requirements for professional qualification of people performing installation, service and
maintenance
Electric connection can be performed only by an acquainted person, i.e. an electrical engineer
with professional education of electrical engineering at an apprentice school or a technical school
(secondary, complete secondary or university education) and whose qualification was verified by
an educational facility authorised to verify professional qualification.
Instructions for operating stuff training
Operation can be performed by skilled personel only trained by production plant, resp. by
contracting service center!
!
!