26
SP 0.1, SPR 0.1
MS ........ synchronous electric motor
N........... controller
R .......... resistor
R
L
......... loop resistance (load resistance)
S3 ........ positional switch "open"
S4 ........ positional switch "closed"
S5 ........ additional positional switch "open"
S6 ....... additional positional switch "closed"
X .......... terminal board
XC .........
connector
Notes:
1. In case that the output signal of the capacitive transmitter (wiring diagram Z239a) is not used (the loop
between terminals 81 and 82 is open) the terminals 81 and 82 are to be connected with a jumper (the jumper is
placed in the plant). If the output current signal is to be used, the jumper is required to be removed.
2. For the EA version with supply voltage of 24 V AC an earthling cable PE is no necessary to be connected.
3. With the version with controller when the feedback from the CPT transmitter is used; at using the output t
signal, this signal isn’t galvanic insulated from the input signal !
4. In case that galvanically separated output signal is needed it is necessary to use galvanical separation
element (is not part of delivery), e.g. NMLSG.U07/B (producer SAMO Automation s.r.o.). After discussion this
module could be supplied by EA producer.
Summary of Contents for SP 0.1
