47
d) Switching the Helicopter on
Move the control stick for the pitch and tail functions (also see
figure 1, item 8) to the bottom position and switch on the transmitter.
Then connect the polarity-reversal protected plug of the helicopter
connection cable to the flight battery at once.
The electronics in the model helicopter now perform an alignment.
Do not move or turn the helicopter during this time.
After approx. 3 seconds, the two swash plate servos move to the
home position, and the swash plate (1) then must be aligned
horizontally (see auxiliary line in the lower illustration of figure 9).
If the swash plate is tilted, use the trim or twist the linkage rods to
precisely adjust the swash plate. For further information on this,
see the following chapters „Trimming the Model Helicopter“ and
„Fine-Tuning the Model Helicopter“.
Now your model helicopter is ready to start.
Figure 9
Summary of Contents for Exceed
Page 130: ...130 ...
Page 131: ...131 ...
