53
Nod trim:
If the helicopter tends to drift forwards, reduce the speed until the helicopter is standing on its skids again safely, and
then push the right one of the two trim buttons for the nod function (also see figure 1, item 2).
Every operation of a button is confirmed by a short signal sound. The percentage shown in the right half of
the display also changes, and the bar display for the nod trimming slowly moves up or down. When resetting,
the centre trimming position (50%) is indicated acoustically with a higher signal sound. The last set value is
stored automatically.
Push the pitch lever carefully forward and check if the adjustment was sufficient. Repeat the procedure until the model
does not show any tendency to drift forward.
If the helicopter wants to drift backwards, push the left one of the two trim buttons for the nod function (see figure 1,
item 2).
Figure 17
If the adjustment areas of the nod and roll trimming are not quite adequate for an optimum correction, you
adjust control of the lower rotor blades mechanically. For further information, refer to the following chapter
„Fine-tuning the model helicopter“.
Summary of Contents for Exceed
Page 130: ...130 ...
Page 131: ...131 ...
