www.reechcraft.com/PowerMast
888-600-6160
49
secti
On
6
TRANSPORT, STORAGE, AND MAINTENANCE
WEEKLY INSPECTION AND MAINTENANCE LOG (2 OF 2)
Component
OK Inspection/Action
Scheduled Maintenance
Be sure that all daily inspection and maintenance have been
completed.
Gearbox
Inspect how gearbox is mounted to climbing unit. Make sure
bolts are secure. Inspect casting of gearbox for any damage
or leaks. Replace gearbox or call your dealer or ReechCraft for
replacement parts.
Lock Lever
While holding the lock lever up, lower the climbing unit. Be sure
that the lock lever can be held in the up position. While standing
next to the erected mast assembly and climbing unit, lower the
climbing unit and drop the lock lever, continuing to clutch the
gearbox for 3 seconds. Ensure the lock lever fully engages the
track and stops the climbing unit.
Overspeed Brake
Inspect the welds and drive gear for any breakage or excessive
wear. Call your dealer or ReechCraft for questions on service
parts.
Drill Bracket
While standing beside the climbing unit, lower the climbing
unit, allowing the lock lever to fully engage the track and clutch
out the gearbox for 3 seconds. When functioning properly,
the drill bracket will place a small down pressure to the drill
assembly and prevent the drill from rotating against the torque
created by the gearbox clutch.
Masts
Inspect the gear track for any broken, misshapen, missing
rungs, or excessive wear. Lug width should be at 95% of new.
Discard track and replace with new if necessary. Check for any
missing screws on the track and replace. Be sure all hardware
is present, secure, and fastens properly. Inspect the top stop of
the mast to ensure it functions properly.
Couplers
Inspect the couplers for any bends, punctures or any other
damage to the tube. Inspect the rivet nuts to ensure proper
thread engagement with the bolt. The rivet nut should not
rotate in the hole. Discard and replace as necessary.
Base Plate
Inspect the base plate for damage and make sure the rubber is
properly attached and in good condition. The locking pin must
be present and working properly.
Ties
Inspect the entire tie for any loose connections, misshapen,
broken or damaged parts. Discard and replace parts as
necessary.
