by ReechCraft
38
secti
On
POwER SYSTEM INSTALLATION
4
1. Installation of the electrical system should only be carried out by a
competent person. Installing electrical components on the system
incorrectly could lead to personal injury or death. Examine the worksite
completely, locating any hazards or conditions such as standing water,
sharp objects, high traffic areas, etc.
2. Important: Before installing any electrical cords, be sure all equipment
has been thoroughly examined for proper function and that no cuts, breaks,
or damage of any kind exists with the electrical supply cords or the
electrical cords on the drills. If any electrical lines are found to be damaged
or have excessive wear, discard immediately and use new equipment.
3. The PowerMast System should only be used with electrical power drills that
have been tested and recommended for use by ReechCraft or your local
dealer. Refer to (Fig. 4.0) for drill and electrical cord requirements.
4. Assemble the supplied 3/8 in.(9.5 mm) driver to the drill. Important: Only
use the driver supplied with the system or equivalent. Do not use a driver
with an integrated magnet as it will not have the necessary engagement on
the gearbox input shaft.
5. Be sure the flats of the driver are seated properly in the chuck jaws
and that there is adequate engagement of the driver to
the drill. Secure the driver to the drill by tightening
the chuck with the chuck key. Keyless chucks
are not permitted.
POWER SYSTEM INSTALLATION
Fig. 4-0
DRILL AND ELECTRICAL CORD SPECIFICATIONS
No Load Speed (High Speed for 1/2 Rated Load)
0-1500 RPM (0-3000 RPM)
Output Power
600 W - 700 W
Input Power
850 W - 1050 W (7.5 - 9.5 Amps)
Maximum Operating Speed @ Rated Load
(@ 1/2 Rated Load)
0-950 RPM (0-1270 RPM)
Maximum Drill Size
13mm (1/2 in)
Collar Size
42.5mm - 44.5mm
(1.68in - 1.75in)
Chuck Type Normal Operation
Keyed Only
(Keyless for Setup Only)
Electrical Cord Minimum Rating
15 Amp 12 Guage Lead
DRIVER INSTALLATION
Keyed Chuck Only
