REDCAT Kaiju, Manual, Page: 17 / 53

Programming Flow Chart
Programming (Continued)
5. The Red LED will flash the number of times that corresponds to the number of the
option listed along the top of the chart. (1 flash = Option 1, 2 flashes = Option 2, etc.)
6. Press and release the set button until the desired number of Red flashes is achieved.
7. To finish set up, turn OFF the ESC.
8. You can now power the ESC back on. The settings should now be saved.
9. Repeat steps 1-8 for each setting you wish to adjust.
Press and release
the SET button
once the desired
number of Red
flashes is
reached.
Turn off
the ESC.
The Red LED
flashes. The
number of
flashes indicates
the program
option on the
chart.
Turn OFF the ESC,
Turn ON the transmitter
Hold the SET key,
Switch ON the ESC
Red LED flashes
Green LED flashes
1 time
Green LED flashes
2 times
Green LED flashes
3 times
Green LED flashes
N times
Enter the 1st item
“Running Mode”
Enter the 2nd item
“Drag Brake Force”
Enter the 3rd item
“Low Voltage Cut-Off”
Enter the Nth item
Red LED flashes 1 time to choose
“Forward with Brake”
Red LED flashes 2 times to choose
“Forward/Reverse with Brake”
Red LED flashes 3 times to choose
“Forward with Reverse”
Red LED flashes 1 time to choose 0%
Red LED flashes 2 times to choose 5%
Red LED flashes 3 times to choose 10%
Red LED flashes 4 times to choose 20%
Red LED flashes 5 times to choose 40%
Red LED flashes 6 times to choose 60%
Red LED flashes 7 times to choose 80%
Red LED flashes 8 times to choose 100%
Red LED flashes 1 time to choose “None”
Red LED flashes 2 times to choose “2.6V”
Red LED flashes 3 times to choose “2.8V”
Red LED flashes 4 times to choose “3.0V”
Red LED flashes 5 times to choose “3.2V”
Red LED flashes 6 times to choose “3.4V”
Press SET key to choose the value, the # of RED
LED flashes means the # of the value (1 flash =
the 1st value, 2 flashes = the 2nd value....)
Press SET key to choose the programmable value,
the RED LED flashes the # of the value you are
choosing. (1 flash = the 1st value, 2 flashes = the 2nd
value....)
Enter the corresponding
programmable item, the RED
LED flashes the current # value
of this item
Finish pr
ogr
amming, switch OFF the ESC, then b
ack ON again
The following steps are just like the above steps...........
Release
SET key
Release
SET key
Release
SET key
Release
SET key
Press
SET key
Press
SET key
Press
SET key
Press
SET key
Hold SET key for 3 more seconds
Hold SET key for 3 more seconds
Hold SET key for 3 more seconds
Hold SET key for 3 more seconds
RCR-2CENR RADIO SYSTEM
ESC
TM
16