REDCAT Kaiju, Manual, Page: 16 / 53

Programming
Calibration
Move the throttle trigger
to the neutral position and
press the SET button.
The Green
LED flashes
once and
motor emits
“Beep”
tone.
Pull the throttle trigger
to the end position of
forward and press the
SET button.
The Green
LED flashes
twice and
motor emits
“Beep-Beep”
tone.
Push the throttle trigger
to the end position of
reverse and press the
SET button.
The Green LED
flashes three
times and
motor emits
“Beep-Beep-
Beep” tone.
1. Turn on the transmitter, set parameters on the throttle channel like
“D/R”, “EPA” and “ATL” to 100% and the throttle “TRIM” to “0”. Disable
the “ABS braking function”.
2. Start with the transmitter on and the ESC turned off but connected to
a battery. While holding the SET button, Turn ON the ESC, then release
the SET button when you see the RED LED on the ESC start to flash
(Note: the motor beeps at the same time). (The ESC will enter the
programming mode if the SET button is not released within 3 seconds,
which will then require you to restart from step 1.)
Press and hold the
SET button
Turn ON the ESC
Release the
SET button
once the LED
flashes.
The Red
LED
flashes
1. Turn on the transmitter.
2. Press and hold the set button on the ESC ON/OFF switch.
3. Turn ON the ESC.
4. Continue to hold the set button until the Green LED flashes the
number of times that corresponds with the item # you wish to
adjust. Refer to the “Item #” column of the chart to determine the
number of Green LED flashes needed.
(1 flash = Running Mode, 2 flashes = Drag Brake Force, etc.)
Press and hold
the SET
button
Turn ON the ESC
The Green
LED flashes.
3. To set the neutral point, leave the throttle trigger at the neutral position, press the SET button. The RED LED dies out and the GREEN LED flashes 1
time and the motor beeps 1 time to accept the neutral position.
4. To set the full throttle endpoint, pull the throttle trigger to the full throttle position and press the SET button. The GREEN LED blinks 2 times and the
motor beeps 2 times to accept the full throttle endpoint, then release the set button.
5. To set the full brake endpoint, push the throttle trigger to the full brake position, press the SET button. The GREEN LED blinks 3 times and the motor
beeps 3 times to accept the full brake endpoint. Release the trigger back to the neutral point. (The motor can be started 3 seconds after the
ESC/Radio calibration is complete)
Programmable
Items
Programmable Value
1 2 3 4 5 6 7 8 9
1. Running Mode
Forward
with Brake
Forward/Reverse
with Brake
Forward and
Reverse
2. Drag Brake Force 0% 5% 10% 20% 40% 60% 80% 100%
3. Low Voltage
Cut-Off Threshold
Non-Protection 2.6V/Cell 2.8V/Cell
3.0V/
Cell
3.2V/
Cell
3.4V/
Cell
4. Start Mode(Punch) Level 1 Level 2 Level 3 Level 4 Level 5 Level 6 Level 7 Level 8 Level 9
5. Max Brake Force 25% 50% 75% 100% Disable
NOTE: The shaded boxes are default settings
RCR-2CENR RADIO SYSTEM
ESC
TM
15
Battery
Battery Battery
Jumper Wire