Intended Audience
x
SmartEdge 100 Router Hardware Guide
•
Transceivers for SmartEdge 100 Optical Ports
Describes the transceiver types and their specifications, including cable data, for SmartEdge 100 native
ports, if so configured, and all Fast Ethernet (FE) and Gigabit Ethernet (GE) media interface cards
(MICs); it also includes how to install a transceiver.
•
Ports, Circuits, and Tunnels Configuration Guide
for the SmartEdge OS
Describes the tasks and commands that you use to configure native ports and MICs, including ports,
circuits, link groups, bridged and cross-connected circuits, and tunnels.
•
Ports, Circuits, and Tunnels Operations Guide
for the SmartEdge OS
Describes the operations tasks and commands that you use to monitor, administer, and troubleshoot
native ports and MICs, including their ports, circuits, link groups, bridged and cross-connected circuits,
and tunnels.
•
NetOp EMS Operations Guide
Provides detailed instructions on configuring, managing, and troubleshooting a network of SmartEdge
routers using the NetOp™ Element Manager System (EMS) software.
•
Redback Networks Glossary
Provides a list of industry standard terms and terms found in the SmartEdge hardware and software
documentation.
Intended Audience
This guide is intended for network engineers who are responsible for the planning and configuration of the
SmartEdge 100 router and qualified (trained) service personnel who install and service the SmartEdge 100
equipment. This guide assumes that readers are familiar with hardware installation and service procedures
in general, but might not have previously installed or serviced a SmartEdge 100 router.
Organization
This guide is organized as follows:
•
Chapter 1, “System Description”
Provides a functional overview of the SmartEdge 100 router, including the chassis, controller card
functions and components, I/O carrier card functions and components, and MIC functions and
components.
•
Chapter 2, “MIC and Native Port Descriptions”
Describes each of the FE and GE MICs that are currently available for the SmartEdge 100 router.
•
Chapter 3, “Preparing for Installation”
Describes planning for the hardware installation, including site and management access requirements,
for the SmartEdge 100 router and its FE and GE MICs.
Summary of Contents for SmartEdge 100
