8-MENU ITEMS AND OPERATION
41
Technical Dept. - All rights reserved - Reproduction is prohibited
Connect the cables from the external thermostat to points 1-2 of the terminal block on the stove.
Once the thermostat has been connected one must enable it.
In order to do this, proceed as follows:
• Press the “menu” button.
• Scroll to "Settings" using the arrows.
• Select by pressing “menu”.
• Scroll once again to "External thermostat" using the arrows.
• Select by pressing “menu”.
• Press the - + buttons.
• Select "On" to activate the external thermostat.
• Press the “menu” button to confirm.
• Press the “esc” button to exit.
f - Auto-Eco activation
To select the Auto-Eco function act as follows:
• Press the “menu” button.
• Scroll to "Settings" using the arrows
• Press "menu" to confirm.
• Scroll to "Auto-Eco" using the arrows.
• Press "menu" to confirm.
• Select "On" with the + - keys.
• Press "menu" to confirm and "esc" to exit.
g - Eco Shutdown t
To select the Eco - shutdown t function act as follows:
• Press the “menu” button.
• Scroll to "Settings" using the arrows
• Press "menu" to confirm.
• Scroll to "Eco - shutdown t" using the arrows.
• Press "menu" to confirm.
• Enter the minutes with the + - keys.
• Press "menu" to confirm and "esc" to exit.
AUTO ECO MODE (see section 8f and 8g)
To activate the “Auto Eco” mode and adjust the time refer to section 8 f and 8 g respectively.
The possibility to adjust the "ECO shutdown t" comes from the need to ensure proper operation in the various rooms the stove can be
installed in and prevent continuous shutdowns and start-ups in the event the temperature is subject to sudden changes (air currents,
poorly insulated rooms, etc.).
The ECO shutdown procedure is activated automatically when all the power demand devices involved in the "system configuration" are
satisfied: room probe/external thermostat (configurations 1-2-3), flow switch (configuration 2), puffer thermostat/ntc (10 kΩ ß3435)
(configuration 4-5) or boiler thermostat/ntc (10 kΩ ß3435) (configuration 2-3). If all devices present are satisfied the "ECO shutdown t"
time decrease starts (by default 10 minutes, it can be changed within the "Settings menu"). During this stage the panel displays ON with
a small flame and alternately Chrono (of active) - Eco active. The minutes indicating the countdown for the Eco Stop are shown at the top
of the display. The flame goes into P1 and stays there until the programmed "Eco shutdown t" time has elapsed and if the conditions are
still satisfied, it goes into the shutdown stage. The ECO switch off countdown resets if one of the devices boosts power again.
