RED DSMC OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC
955-0020_V5.2, REV-G | 153
SET UP MOTION CONTROL (MOCO)
Motion Control, or “MoCo” for short, is a form of sensor synchronization used to automate precision camera
movements required for special effects and difficult shots. Motion Control uses GPIO signals transmitted
using the SYNC (GPI) and CTRL (GPO) ports on the camera BRAIN or a connected Pro I/O Module or
4K Broadcast Module.
For more information GPIO connections, go to
“Input/Output Connectors” on page 174
.
NOTE:
When using MoCo, set the frame rate to be at least two times (2x) the fastest trigger rate used. When
using MoCo, REDCODE is calculated based on FPS/2. Therefore, if you are in MoCo mode, and the frame rate
is 100.83 FPS, the maximum REDCODE is calculated based on a frame rate of 50.415 FPS.
NOTE:
HDRx is not available when MoCo is enabled.
NOTE:
Genlock and timecode can also be used with MoCo.
To set up MoCo, follow the instructions below:
1. Connect the Motion Control device to the BRAIN using a 3BNC-to-00 LEMO Sync Cable.
‒
Sync In:
Connect the white BNC connector to the Motion Control device and the 00B LEMO connector
to the
SYNC
port on the BRAIN.
‒
Sync Out:
Connect the yellow BNC connector to the Motion Control device and the 00B LEMO connec-
tor to the
CTRL
port on the BRAIN.
2. Go to
Menu
>
Settings
>
Setup
>
GPIO/Sync
.
3. On the
Sync
tab, set
Sensor Sync Mode
to
MoCo
.
4. Set
Genlock Source
to
Brain
.
MoCo GPIO/Sync Settings
Summary of Contents for DSMC DRAGON
