Description
4
BAL_S20_EN_1V0_REC_121-006454590
18/ 33
Safety equipment and operating elements
Pos.
Components
Pos.
Components
1
Trigger and safety sensor / combinati-
on sensor (inside and outside)
3
Key switch BDE-V (option)
2
Control unit BDE-D
4
Manual release
Opening and security sensors (combined)
Each passage area is monitored with opening and security sensors. If an opening or security sensor
is activated during the closing process while in
AUTOMATIC
or
ONEWAY TRAFFIC
operating mode,
then the respective sliding door will re-open/reverse again.
Collision detection
If a door wing hits an obstacle during the closing process, then the door will stop immediately and re-
open.
Equally, the door wing will stop immediately if the door hits an obstacle during the opening process.
The opening process will start anew after 3 seconds at extra slow speed.
Security sensors side panel
The opening area of the door wing (inside) is monitored by security sensors. The function of the sen-
sors is tested before each opening. If there is detection during the opening process, the door will stop
immediately and closes again.
Components of the system
Pieces Designation
Mounting location
Switches and buttons
1
Key switch
Indoor or outdoor
Opening and safety sensors
2 / 4
Combi sensors
Upper guide - inside and outside
Drive technology
1 / 2
Motor ATE
In drive technology
1 / 2
Control Type: System 20
In drive technology
1
Bistable locking system - Type: VRR 20 for floor hoist
In drive technology
1
Emergency release (shell handle)
In drive technology
4.2
4.2.1
4.2.2
4.2.3
4.3
