any danger caused by squashing, conveying and
shearing, according to and in compliance with the
applicable directives and technical standards.
• Keep the photocell optical components and
luminous signal indication devices clean. Check
that the photocells are not obscured by branches or
shrubs.
• For any direct assistance to the automation
system, request the assistance of a qualified
technician (installer).
• Have qualified personnel check the automation
system once a year.
• Entrance is reserved for vehicles, provide a
separate entrance for pedestrians.
3) SCRAPPING
Warning: This operation should only be carried out
by qualified personnel. Materials must be disposed
of in conformity with the current regulations. In case
of scrapping, the automation devices do not entail
any particular risks or danger. In case of materials
to be recycled, these should be sorted out by type
(electrical components, copper, aluminum, plastic
etc.).
4) DISMANTLING
Warning: This operation should only be carried out
by qualified personnel. When the control unit is
disassembled to be reassembled on another site,
proceed as follows:
• Disconnect the power supply and the entire
electrical installation.
• In the case where some of the components cannot
be removed or are damaged, they must be replaced.
5) FUNCTIONS
FOR THE INSTALLER: Fill in the table with the
parameters set, in order to facilitate future
modifications and maintenance operations.
The preset values are indicated between square
brackets [ ].
WARNINGS
Correct controller operation is only ensured
when the data contained in the present manual
are observed. The company is not to be held
responsible for any damage resulting from failure
to observe the installation standards and the
instructions contained in the present manual.
The descriptions and illustrations contained in the
present manual are not binding. The Company
reserves the right to make any alterations deemed
appropriate for the technical, manufacturing and
commercial improvement of the product, while
leaving the essential product features unchanged,
at any time and without undertaking to update the
present publication.
ATTENTION! The IGEA-BT model controller is not
equipped with mechanical torque adjustment. It
is compulsory to use a control panel of the same
manufacturer, in compliance with the basic safety
requirements of directives 73/23/CEE, 89/336/
CEE, 89/37/CEE equipped with appropriate electric
adjustment of the torque.
Correct controller operation is only ensured
when the data contained in the present manual
are observed. The company is not to be held
responsible for any damage resulting from failure
to observe the installation standards and the
instructions contained in the present manual.
The descriptions and illustrations contained in the
present manual are not binding. The Company
reserves the right to make any alterations deemed
appropriate for the technical, manufacturing and
commercial improvement of the product, while
leaving the essential product features unchanged,
at any time and without undertaking to update the
present publication.
