Page 14
Autoset Programming
Real Carriage Door & Sliding Hardware Copyright 2020© all rights reserved
Autoset Programming
for Quick Setup
The Franklin Autoswing comes “out of the box”
with preprogrammed defaults that allow the unit
to function with just a small amount of initial setup
programming.
NOTE:
Make sure the doors are in the closed
position before running the Autoset. If one door
has an astragal watch carefully that the doors do
not bind. Unplug power cord quickly if need be.
1.
Press the [OK] button once
•
The display will read “LANG” (language)
followed by “ITA” (Italian)
• Scroll down using the minus [-] button until you
see “ENG” (English) displayed
•
Then press the [OK] button
2.
The word “TYPE” will be displayed briefly
•
Press the minus [-] button until “IGEA” is
displayed
•
Then press [OK]
3.
The next screen will display “N. MOT” (Number
of Motors)
• Scroll down with the minus [-] button until “2” is
displayed
•
Press [OK]
Note:
If only installing one motor, choose “1” then
press OK.
4. “DR” (Direction) will now be displayed for a
moment followed by “INT” (interior)
•
Select “INT” and press [OK]
5.
Next “PRESET” will be displayed, followed
immediately by “AR” (Automatic Residential)
•
Scroll down to “SR” (Semi-Automatic
Residential). This allows the doors to work like a
typical garage door
•
Press [OK]
Note:
AR will cause the doors to automatically close
on their own, SR requires you to press a button to
close.
6.
After selecting your preset, the screen will
display “PROG” (programming) for a few
seconds
•
The screen will then display “AUTOSET”
•
Be sure the path of the doors is clear of traffic
and obstructions. Be aware that the doors will
run at full torque during the process
•
Press [OK] when ready
• The motors will run full open and close cycles
more than once (to learn the force required to
open and close the doors)
•
“OK” will be displayed
•
Press the [OK] button to continue
Note:
If the motors do not run and/or “KO” is
displayed press [OK] to display error code. Check all
wiring, fuses, photo eye alignment and wiring.
Programming the Remotes
1.
The display will read “MEM. REMOTES”
(Memorized Remotes)
•
Immediately followed by “HIDDEN BUTTON”
2. Firmly press and hold the top two buttons on
your remote (this is the hidden button)
•
When the screen reads “RELEASE”, release the
two buttons
3.
The screen will then read “DESIRED BUTTON”
•
Press and release the button you wish to
operate the doors with
4. The screen will display “HIDDEN BUTTON”
again
• You can repeat the remote leaning process
(Steps 1-3) or press [OK] to end
Programming after the completed Autoset
If the doors are in the closed position after the
Autoset is complete you can move on to Step 2.
If they end in the open position, then you need to
adjust your programming and follow the instruction
for step 2.
1.
To get into the programming menu press [OK]
