Real Carriage Door & Sliding Hardware Franklin Autoswing, Installation Manual

Page: 19 / 40

Page 19 Terminals Explained
Real Carriage Door & Sliding Hardware Copyright 2020© all rights reserved
Ter -
mi -
nal
Name Descrip -
tion
Default Notes
78 FAULT 3 Safety
input
#3
FAULT Re -
quires
oppo -
site re -
lay state
from
SAFE 3
SAFE 2 and SAFE 3 can be programmed to perform
any of the following instructions under the “LOGIC”
sub-menu:
Range Value Function Description
000 PHOT System reacts
to the input in
both opening
(stops) and
closing (revers -
es) cycles
001 PHOT TEST Same as
above. Re -
quires the de -
vice to super -
vised (FAULT
active)
002 PHOT OP System reacts
to the input
only during
the opening
cycle (stops)
003 PHOT OP TEST Same as
above. Re -
quires the
device to be
supervised
(FAULT active)
004 PHOT CL System reacts
to the input
only during the
closing cycle
(reverses)
005 PHOTO CL
TEST
Same as
above. Re -
quires the
device to be
supervised
(FAULT active)
Range Value Function Description
006 BAR Safety edge in -
put. It reacts in
both opening
and closing. It
stops and par -
tially reverses
007 BAR TEST Same as
above. Re -
quires the
device to be
supervised
(FAULT active)
008 BAR 8K2 Safety edge
input with
EOL resistor
as supervision
method. Only
active on SAFE
2
009 BAR OP Safety edge
input. During
opening it
stops and par -
tially reverses.
During closing
it stops
010 BAR OP TEST Same as
above. Re -
quires device
to be super -
vised (FAULT
active)
011 BAR OP 8K2 Safety edge
with EOL resis -
tor as supervi -
sion method.
During open -
ing it stops
and partially
reverses.
During closing
it stops. Active
only on SAFE 2
012 BAR CL Safety edge
input. During
closing it stops
and partial -
ly reverses.
During open -
ing it stops.