Page 25
Homelink
Real Carriage Door & Sliding Hardware Copyright 2020© all rights reserved
Homelink
For programming troubleshooting please see out
Homelink troubleshooting guide, it can be found on
www.realslidinghardware.com
under Tech Info.
Transmitter Individualization:
•
Open up the transmitter by prying on corner as
illustrated
• Change the transmitter code by moving the
switches on the dip-switch bank.
• Carefully close transmitter by snapping
enclosure back in place.
Transmitter Programming:
•
Open the transmitter by prying on corner as
illustrated
• Change the transmitter code by moving the
switches on the dip-switch bank.
• Carefully close transmitter by snapping
enclosure back in place.
Receiver Memory Deletion:
•
Press and hold P1
•
WITHOUT RELEASING P1, when the LED lights
up, press & hold P2 for 10 secs.
•
Release both buttons.
LED will flash 6 times
indicating memory
deletion.
Programming to the Thalia
Board
1. The Homelink receiver
has two channels; the
blue and yellow are Ch.1,
and green and orange
are Ch.2. The power
supply is black and red.
•
Black goes to 50
•
Red to 51
•
Blue to 60
•
Yellow to 61
2. The green and orange
are not needed unless
you want to use Ch.2,
which can be used for
pedestrian command. If you do need Ch.2:
•
Orange goes into 60
•
Green into 62
3.
Lastly be sure to program IC1 value to 000 on
your control board for Ch.1.
•
On the control board please press [OK] twice
quickly
• “HALT” will appear on the display
4. Press [OK] twice again
•
“PARAM” will appear on the display
5.
Press the [–] button one time and the display
show “LOGIC”
6. Press the [OK] button
• “TCA” will appear on the display
7. Press the [-] button until you see “IC 1”
•
Adjust the “IC 1” to value of 000
8.
Press [OK]
9. Press [+] and [–] at the same time to exit the
menu
