Page 27
Outdoor Keypad
Real Carriage Door & Sliding Hardware Copyright 2020© all rights reserved
•
Press [OK]
• The display will read “Add StArt”
•
Press [OK]
3.
Press [ON] on the keypad
4. Green LED will blink twice
5. Wait 5 seconds
Changing the default code for Channels
1.
To change the default code press and hold [ON]
button on the keypad
•
Make sure red LED light is on
2.
Press [1] [1] [1] [1]
•
Press [OK]
•
Red LED light will be fixed and green LED will
blink
3.
Enter the desired 4-digit code sequence
•
Press [OK]
•
Red LED light will be fixed and green LED will
blink
4. Repeat step #3 to confirm new code
5.
Green LED light will be fixed
Additional Codes
1.
Press and hold the [ON] button on the keypad
until the red LED light is on
2.
Press [1] [2] [3] [4]
•
Press [OK]
•
Red LED light will be fixed and green LED will
blink
3. Enter the current Channel 1 passcode
•
Press [OK]
•
Red LED light will be fixed and green LED will
blink
4. Enter the desired 4-digit code sequence
•
Press [OK]
•
Red LED light will be fixed and green LED will
blink
5.
Repeat step #4 to confirm new code
6. Green LED light will be fixed
Changing a current passcode
1.
Press and hold the [ON] button on the keypad
until the red LED light is on
2. Enter current passcode
•
Press [OK]
•
Red LED light will be fixed while the green LED
light blinks
3.
Enter the desired 4-digit code sequence
•
Press [OK]
•
Red and green LED should be fixed
4. Repeat step #3 to confirm new code
5.
Green LED light will be fixed
Regular Use of outdoor Keypad
1.
Press [ON]
2. Enter in passcode
•
Press [OK]
•
Green LED light will be fixed
3. Doors will open
Outdoor Keypad Reset
1.
Remove batteries from the keypad
2.
Remove the jumper from one leg as shown in
picture and insert jumper grabbing both legs
3.
Insert batteries and wait for unit to stop
beeping and flashing
4. Once these alerts stop, remove the batteries
5.
Remove the jumper off both legs and reinsert
onto one leg
6. Insert
batteries
and start
over with
instructions
