Copyright © 2006 REA Elektronik
Seite 15
Rationalisierung
Entwicklung
Automation
Elektronische Geräte und Systeme
6.
Connecting cables:
With the bayonet nut connector
you connect the print head to the
connector on the back panel of
the controller (19-pin plug cable
for 7-dot print head, 35-pin plug
for 16-dot print head).
7. Connect the controller on it´s
backside with the print head.
8. Connect the product sensor with
the connecting cable.
9. Connect the shaft encoder to the
controller.
10. Connect the controller on it´s back
panel side with the eight-pin plug
(Y-cable
– PS/DG-cable) to the
product sensor and the shaft
encoder.
Connect the input terminal with it´s
12-pin plug to the front panel of
the controller.
Attention: the controller must be
turned off while doing so.
