Copyright © 2006 REA Elektronik
Seite 24
Rationalisierung
Entwicklung
Automation
Elektronische Geräte und Systeme
Check plungers for dirt particles and remove
them without hurting the plunger. Rinse after
cleaning.
Assemble the nozzle plate sealing ring.
Put the nozzle plate back in place into notch.
Make sure that the pin comes to rest in the pin
hole of the nozzle plate.
Screw the nozzle plate screws back on and
tight screws alternately.
The print head is now ready to go back into operation. Take into account that the print head might
need to be vented again to exhaust any air inside. For venting process go back to table in chapter
8.2 and see step 21.
In case of heavy pollution which can not be cleaned in ultrasonic bath a cleaning needle has to be
used to clean the nozzles.
Insert the nozzle cleaning needle only when nozzle
plate is dismantled. Insert direction of needle is from
outside in to get rid of any blockage.
plunger
Pin hole
pin
