The Remote Control
Find out if the remote can operate your TV
This remote control is designed to operate most RCA, GE, and Proscan TVs.
1. Press the TV button.
2. Press the ON•OFF button (if the TV turns on or off, this remote will operate the TV.
3. If that doesn’t work, you can try programming the remote by following the instructions
below.
Programming the Remote to Operate your TV
The remote can be programmed to control many brands and models of remote
controllable TVs.
1. Turn on the TV.
2. Look up the brand and code number(s) from the list on page 9.
3. Press and hold the TV button on the remote while pointing the remote at the TV.
4. Keep holding down the TV button, and enter the first code from the code list for your
brand.
5. Release the TV button.
6. Press ON•OFF to see if the TV turns off. If it doesn’t, press the TV button and then press
ON•OFF. If you get no response, follow steps 1-4 again, but enter the next code from the
code list for your brand of television.
Note: This remote may not be compatible with all brands and models of televisions.
Programming the remote to operate other components (VCR, satellite
receiver, etc.)
This remote is already programmed to operate most RCA, GE, and Proscan VCRs and satellite
receivers — just press the corresponding button (i.e., VCR button for VCR, SAT•CABLE button
for a satellite receiver). If you have other brands, follow the instructions for Programming the
Remote to Operate Your TV, but press the component button that applies to the component
8
chapter 2
Graphics are for representation only. Your unit might differ from pictures in this book.
DRC700N.part1.7.26.02 8/1/02 11:05 AM Page 8
