UM-1097
Revision B
6
o
4 Option Boards
o
Expansion Plate adds up to 6 Option Boards
•
71P-05 Half Width 19” Rack/Panel Mount
o
1 Option Board
3.2
Power and Analog Outputs Wiring
WARNING
: Qualified personnel should perform the installation according to applicable
electrical codes, regulations and safety standards. Ensure correct cabling and sealing fitting
practices are implemented. Do not aim the sensor pointing upward.
3.2.1
DC Power Supply
Standard ViewSmart 1600+ power requirements are 10-30VDC @ 12 watts applied to terminals 1 & 3(+)
and 5 & 7(-) of TB4 on the standard I/O Board. Optional features increase power consumption as described
below:
1.
Discrete Relay Board option; add 3.5 watts per board (assumes all 8 relays are energized).
2.
Programmable Relay Board option; add 3.5 watts per board (assumes all 8 relays are energized).
3.
Analog Input Board option; add 1/2 watts per board plus transmitter power consumption.
4.
4-20mA Output Board option; add 2.5 watts per board.
5.
Bridge Sensor Input Board option; add 3 watts max per board with four 10-0192 modules installed
(power consumption of the sensors not included).
6.
Auxiliary Standard Relay Board option; add 2.5 watts.
7.
Isolated Serial Expansion Board; add 1.5 watts.
8.
TB4 terminals 2, 4, 6 & 8 of the standard I/O Board provide a maximum of 500mA fused output
power for powering of auxiliary external devices such as relays, lamps or transmitters. Power
consumed from these terminals should be considered when calculating system power
consumption.
3.2.2
AC Power Supply
Optional AC power supplies are available for applications requiring local AC power connections. When
installed at the factory, the 24VDC output will be wired to the Main I/O and to any connected optional I/O
boards.
3.2.2.1
Optional 150 Watt 110-240VAC – 24VDC Power Supply
The ViewSmart 1600+ Controller may be powered from 10-30VDC. However, many applications require
24VDC power for the monitors or transmitters providing inputs to the ViewSmart 1600+. A 150 watt AC /
DC power supply may be included for these applications (115VAC or 230 VAC selected via slide switch).
When ordered from the factory, it is pre-wired to provide 24VDC primary power for the ViewSmart 1600+
controller as well as any transmitters or monitors that may be connected by the end user.
Summary of Contents for ViewSmart 1600+
Page 77: ...UM 1097 Revision B 67 4 7 5 4 Programmable Relays Figure 47 Webpage Programmable Relays Menu...
Page 78: ...UM 1097 Revision B 68 4 7 5 5 System Configuration Figure 48 Webpage System Configuration Menu...
Page 134: ...UM 1097 Revision B 124 Appendix 4 Menu Navigation...
Page 141: ...UM 1097 Revision B 131 Wireless Options and Accessories Expansion Options...
