RC Systems ViewSmart 1600+, Operation Manual

Page: 36 / 141

UM-1097
Revision B 26
4.3.2 System Configure Menu
Some items needing configuration are not specific to a channel but affect the entire ViewSmart 1600+
system. These are located in the
Configure entry menu shown on the right side of the figure below. System
Configuration menus are accessed by pointing to the desired item and pressing Edit.
Configure
Zone Names
Mimic Mode
SD Card
View Event Log
Clear Event Log
View Sensor Life
Version
~
~
~
~
~
~
~
v1.00
System
Brightness
Date
Time
Enable Channel Count
Display Alarm
Warmup Time (min)
Cal Purge Time (min)
Zone Screen Enabled
Block Negative
Relay Refresh (min)
Name
Night Mode
10/20/2010
09:43:28
Count 16
Main Data
1
1
Yes
Yes
0
Unit-72-3967
Configure
Figure 19 System Configuration Menu
4.3.2.1 Name
Assign the controller a name for use in the backup configuration file name on the SD card. The controller
name is limited to 16 characters.
4.3.2.2 Brightness
The Configure menu item identified as Brightness allows users to adjust the LCD brightness based on three
levels, Normal, High and Night Mode. To adjust the brightness level suitable to the ambient lighting,
highlight
Brightness and press Edit to cycle through the available settings, and press Next to accept the
desired setting.
4.3.2.3 Date and Time
Adjust the date and time here for use in Data and Event Logging. This is a factory setting but may need to
be adjusted to reflect the end user’s location.
4.3.2.4 Enabled Channel Count
For applications that do not need 16 channels, the ViewSmart 1600+ can be configured to display
channels
.
With fewer channels to be displayed in Main Data screen the cells expand for better resolution.