RC Logger NovaX 350, Operating Instructions Manual

Page: 42 / 52

42 | Using A Camera
> When you have familiarised yourself with the »NovaX 350’s flight properties, you may
perform additional exercises.
» Start with simple flight manoeuvers like flying a metre forwards/back (nod
function), then
» Practise hovering to the left/right (aileron function). When you have the practice
you need, start flying circles and figure eights.
32. USING A CAMERA
32.1 Introduction
You have the possibility to attach a camera to the »NovaX 350’s carbon fibre platform
located under the body. It is also possible to attach a gimbal to the »NovaX 350 for aerial
photography purposes. Any camera used must be self-sufficient.
The platform is rubber-cushioned and thus assists in eliminating vibrations reaching the
camera. The platform features various slots and drill holes for mounting cameras.
Make sure the camera is not taller than the available
clearance between the camera platform and the ground.
32.2 Attaching the camera
32.2.1 Action mounts
There are suitable action mounts available from www.rclogger.com , which can be directly
mounted onto the camera platform (14) and are compatible with some RC Logger action
cameras.
32.2.2 Double-sided tape
> A convenient way to mount a camera is with double-sided tape. Ensure the tape’s
adhesive force can hold the weight of the camera, also during disturbances. You are
advised to consult a professional assisting you in selecting the best suitable tape.
> Clean the carbon platform before attaching the tape. Fat, grease and dust decrease
adhesive strength.
After sticking the tape to the platform, let it rest for 24 hours
in order for it to reach its full adhesive strength.
32.2.3 Alternative mounting methods
Depending on your camera, the mounting may require some grade of improvising. Always
make sure the weight is carefully balanced in all four directions and no part touches the
propellers/rotors during operation.
32.3 Attaching a gimbal
32.3.1 Gimbal platform
There is an additional gimbal platform included in delivery you can make use of when
mounting the gimbal. Swap the camera platform for the gimbal platform [ Fig. 20 ] .
32.3.2 Connecting the gimbal
Consult the operating instructions of
your gimbal for instructions relating to
gimbal control.
The gimbal must be self-sufficient.
That is to say, it must be supplied
with power by a second battery or a
camera.
There are two 3-pin header
connectors, one for the
X-AXIS and
the other for the Y-AXIS , allowing
you to control the gimbal via your
transmitter.
26 mm
20 mm
10 mm
Fig. 20