Razorgage Cyclone RazorOptimal, User Manual

Page: 28 / 55

Cyclone RazorOptimal User Manual
28 | P a g e
Technical Services, Inc.
Saw Feed Flow Controls
The saw blade feed rate is adjustable with pneumatic flow controls. This adjustment may be necessary
if material thickness and/or width changes. Also, a saw timeout error may be a reason to make this
adjustment. The flow controls for saw feed rate are located at the back of the machine in-between the
valve and the FRL. There is a flow control for retract on the left and one for advance on the right. Loosen
the locking thumb nut before adjusting. Adjust by turning the dial clockwise to close the flow which slows
motion or turning counterclockwise to hastens motion.
Use precaution when making adjustments to
saw feed rate. Changes to saw blade feed rate can affect cut quality.
To test saw, go to SAW STOP MODE from the MAIN SCREEN and move the pusher out to high limit to
get it out of the way. Now place a test piece of board under the top clamp and against the fence. Enter
a value equal to the current position, select MOVE +SAW
, then press GO. The pusher won’t move
because it’s already in position but the operation selected will be performed. Check saw feed rate as
the saw is cycling and adjust flow controls to change advance and retract speed as needed.