Razorgage Cyclone RazorOptimal, User Manual

Page: 17 / 55

Cyclone RazorOptimal User Manual
17 | P a g e
Technical Services, Inc.

PUSHER TO SAW AT LOW LIMIT
– This value is the home offset and is set through the machine
calibration process. Default is 0.5 inches

LOW LIMIT
– This value is the lowest position that the RazorGage is capable of moving. It does
not need to be modified and cannot be selected from this screen.

HIGH LIMIT
– This value is the highest position that the RazorGage is capable of moving. It
does not need to be modified and cannot be selected from this screen.

FIRST MOVE/CLAMP POSITION
– The position from the end of the board to the saw at which
the infeed clamp will begin to activate. Default is 3 inches.

CLAMP SWITCH POSITION
– When the pusher position less than or equal to this value then
the outfeed clamp is used instead of the infeed clamp. Default is 12 inches.

OUT-BOARD CLAMP OFFSET
– Distance from the outfeed clamp to the saw blade. Default is
4 inches.

MOTION ERROR UNLOAD DISTANCE
– Distance the RazorGage will backup on a motion error
or stall to allow room for board removal if necessary. Default is 4 inches.
Now press the MOTION button on the left-hand side of the screen. These parameters control the
speed, acceleration, and deceleration of the RazorGage. The MOVE TO RUN START SPEED is the
first move of the board run. It is an intentionally slower move to keep the board close to the back fence
until it is supported by the guide rollers and side clamps. RUN CURRENT is the percentage of current
applied to the motor which determines the effective torque of the RazorGage movement. Set the
parameters to the values shown below.
Motion Parameters