Razorgage Cyclone RazorOptimal, User Manual

Page: 14 / 55

Cyclone RazorOptimal User Manual
14 | P a g e
Technical Services, Inc.
Setup Procedure
Set the Home Offset (PUSHER TO SAW AT LOW LIMIT). Follow the steps below after starting the
software and homing the machine.
Touch in the MOVE TO POSITION box, enter the number 16, touch the MOVE ONLY radio button, and
press GO. Now take a board longer than 16” with a squared end and put the square end against the
pusher face and seat it against the fence so it is in position to be cut. Again type 16 in the MOVE TO
POSITION box, click MOVE + SAW, and press GO. THE SAW WILL CYCLE. Remove the part from
between the PUSHER AND THE SAW and press the CALIBRATE BUTTON.
Saw Stop Screen
Measure the part you just cut and In the CALIBRATE screen enter 16 as the LAST POSITION and the
measured length of the part as the MEASURED PART LENGTH. Press CALIBRATE and then press
CLOSE You have now set the home offset.