When all of the desired selections have been completed on the
SCREEN
COLORS
menu, press
to return back to the previous display
mode.
Menu
When you are using the
mode, spe-
cial setup operations can be performed
ing
key and selecting
menu from the
MAIN
menu with the
The
menu will appear as shown in the
figure. On this menu you can select
CONTROL menu, the PLOT DISPLAY menu, acti-
vate an External Route input, or reset the Trip
Log counter.
3d3.1
TRACK
Menu
PLOT TEMP MENU
CONTROL
PLOT DISPLAY
INT
T. LOG RESET
TO
PRESS MENU TO
While you are in the
mode display, you may wish to SAVE a
particular track so you can reuse the same route over and over again. The
TRACKCONTROL menu activates the
Recording feature, or erases the
old Trackline from memory. Each of these tasks can be
easily
performed
by
selecting TRACK
with the
from the
menu.
Saving
The Track Plotter normally draws tracking lines
on the Plot screen as the vessel moves along.
However, these track lines are only “temporary”
and are always lost whenever changing plot
scales, changing operating modes, or upon
ing the echosounder unit OFF or ON.
You can record and save a single important
vessel track to keep in memory of your vessel’s
TRACK INTERVAL
LINE
ENTER
trip so you can return home byretracingthe same
route. Recording a track is easily done by
ing the TRACK
to select a
desired track recording interval.
The plotter can
remember
up
to 500
track
points, so the recording interval
selected will be important in determining how quickly track memory will
OPERATION 77
