You can use SHALLOW
and DEEP alarms . ..or the
FISH
alarms, . ..but not
both types together.
DEEP Alarm
DEEP water alarm sounds when the water depth is at or greater than the
operator’s preset depth level.
To set a Deep Alarm depth, press
key. On the
SELECT AL
A R
M
menu, press the SOUNDER ALARMS
screen appears, as shown.
the
and then use the
SOUNDER
(
u
p
)
direction key to set the desired
DEEP
alarm depth
level. The
DEEP
alarm digital value is indicated to the
right of
on the menu and a graphic bar begins
at the bottom right edge of the range scale and rises
,
upward as you press the (up) direction key. Use the
digital value appearing next to
DEE
P
or the end of the
graphic bar to set the desired depth at which the
DEEP
alarm should activate.
Use the (down) direction key to reset the
DEEP
alarm if you overshoot the intended set point.
to return back to the previous display mode.
The alarms are now set. The Alarm bar indicators at the right edge of the
depth scale remain displayed on the fishfmding displays so you can see the
levels at which the alarms are set to activate. When one of the alarms is
activated by the bottom echo, you will see the on-screen blinking alarm
message and hear the audible beeper warning.
If for some reason you do not wish to hear the audio alarm, you can press
the
turn the buzzer “OFF”. The alarm audio stays inactive until
the a rm condition has been cleared. If the alarm condition re-occurs, the
audio alarm will be re-activated. The
may be permanently turned
OFF in the ALARM menu with the
in the menu.
OPERATION 56
